Ndustrial grade hydraulic directional valve used in high volume OEM equipment. These valves are used to control the hydraulic flow path to an actuator (cylinder or motor). The variety of spool options available allow for various movement types based on the application requirements of your cylinder or motor. Useful to switch actuator directions and to fully stop cylinder or motor when centered. Make sure there is a relief valve (VMR6-P-R-30-1) to protect overrunning loads from spiking the pressure during sudden stops when centering. Note that it is normal to have slight leakage of oil across the spool in the center position and slow drifting of the actuator could be possible. If this is an issue use the T spool with a P. Actuators will move freely from external forces when the valve is in the center position. Motors and cylinders will coast to a stop when centering. Adding an A&B port P. Check valve (VMCP6-AB-1) under this valve will ensure a positive stop and hold the position of a motor and cylinder for longer durations than with just a closed center spool valve C. Commonly used with fixed displacement gear pumps so pressure can flow direct to tank and not build up heat. All ports open to tank in the center >D03 (NG6) Cetop mounting can be mounted to standard available sub plates and bar manifolds. >Maximum flow of 21 gpm for DC power and 15.8 gpm for AC (reference Solenoid Power limit chart) >Maximum working pressure = 4560psi (315 Bar) >3-position, 4-way, Spring centered, energize to shift double solenoid Robust design proven in many high-volume original equipment manufacturers machines. Includes mounting bolts (M5x45mm long) Rated IP65 for dust and water resistance. Includes lighted DIN connector for each coil. LED illuminate’s clear connector housing when power is supplied to the connector/coil. Used in mobile, industrial. Solenoid Power: DC= 30 watts, AC = 50VA (220VA inrush) Operating temperature = -22? F to 174? F Valve can be mounted in any direction.